If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
V or Parting Tool Measurement
Hello,
What is the correct reference for measuring the size of a V tool? Is it the width between the two angled cutting edges at their top or the length of each individual edge? For instance a No. 39 V in a 1/2" size would be 1/2" between the tops of the two cutting edges or the width of each of the two cutting edges would be 1/2"? Is that clear as mud or what. thanks, Ed |
Ads |
#2
|
|||
|
|||
the 1/2" is the length of each leg
bob |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
New Thunderbird Looping Tool? | Mj | Beads | 3 | June 26th 04 09:13 PM |
I get a new tool! | Kalera Stratton | Beads | 9 | June 12th 04 08:05 AM |
Osibin Lentil Tool Question | Juanita Floyd | Beads | 7 | April 10th 04 11:02 PM |
AD: Lampworking Tool, Burgard Caps and Furnace Glass | Tinkster | Beads | 0 | February 24th 04 08:25 AM |
Which Tool? | BUB 209 | Carving | 4 | October 1st 03 05:02 PM |