If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Knitting motor question
Hi,
I was wondering if anyone is using a Knitking/Brother knitting motor, and if so, if you could answer a quick ? for me. When I had it set up to run with my bulky machine, there was a gap between the bar that hooks it onto the motor drive, now that I've connected the standard gauge machine it appears the machine is sitting too high for the connector. Did anyone else have this problem and how did you resolve it? I'm just baffled. Thanks, HL |
Ads |
#2
|
|||
|
|||
Knitting motor question
On Oct 17, 4:44 pm, hippielady wrote:
Hi, I was wondering if anyone is using a Knitking/Brother knitting motor, and if so, if you could answer a quick ? for me. When I had it set up to run with my bulky machine, there was a gap between the bar that hooks it onto the motor drive, now that I've connected the standard gauge machine it appears the machine is sitting too high for the connector. Did anyone else have this problem and how did you resolve it? I'm just baffled. Thanks, HL There are 2 sets of screws in the front, front set for bulky, back set for regular gauge. Need to make sure you are using the right positions. A |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
new motor for shimpo rk2 for sale | arkey03755 | Pottery | 1 | July 18th 11 05:03 PM |
Atlas motor usage | TheDormouse | Polymer Clay | 4 | January 20th 07 07:38 PM |
foredom micro motor | tom kroll | Carving | 0 | April 20th 06 03:17 PM |
OT washing out motor oil smell? | Julia Altshuler | Quilting | 17 | December 23rd 04 09:00 PM |
Need help motorizing a 1963 Schwinn with a DC motor | CapriciousD | General Crafting | 7 | September 5th 04 12:00 AM |