If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#9
|
|||
|
|||
Cutting jump rings
I too have a Pepe jump ring maker. The instructions are less than
satisfying. I finally figured out that I had the blade in backwards. Is there a brand of blade that anyone would recommend? They are all expensive, but if one is better than another I am willing to try it. (I just ordered enjun joes grease. It certainly is reasonable in price.) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Soldering jump rings | [email protected] | Beads | 0 | January 21st 08 04:09 PM |
Where is the best place to buy jump rings? | WeeWilly1 | Beads | 14 | August 6th 05 07:48 AM |
Review: Snapeez Jump Rings | Kandice Seeber | Beads | 0 | July 22nd 04 01:44 PM |
Soldering Jump Rings | Raane | Jewelry | 10 | March 16th 04 04:28 PM |
Silver jump rings? | Harry | Beads | 18 | January 27th 04 05:42 PM |