If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Breaking thread on loom
I'm using a 80/20 cotton as warp and am breaking the threads from
each side. Any suggestions? Many thanks. |
Ads |
#2
|
|||
|
|||
Breaking thread on loom
|
#3
|
|||
|
|||
Breaking thread on loom
"Richard Eney" wrote in message
... I'm using a 80/20 cotton as warp and am breaking the threads from each side. Any suggestions? Many thanks. The middle threads don't break, so presumably the tension is correct. Less force applied when throwing the shuttle? Or don't tighten it as much when beating it in? =Tamar Or perhaps a floating selvedge on each side? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Breaking thread on loom | [email protected] | Needlework | 2 | June 20th 07 02:31 AM |
Thread breaking | Cindy Schmidt | Quilting | 13 | May 10th 04 03:11 AM |
Help! Thread breaking at feet | Mary Hill | Quilting | 12 | November 27th 03 10:19 PM |