If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Clay gun update
The one I remembered as "from Pro Arts" at Michaels turned out to be by
Loew Cornell. And it was TERRIBLE. When I finally gave up and started to clean it, and then examined it again (because it was weirdly difficult to clean), I found out that only the last inch on either end of the barrel had a smooth finish. The center section was very badly cast and not finished. Needless to say, it's going back for a refund today. Luckily, as I was at the checkout at Michaels, the customer service manager who was there recommended Tall Mouse to me. What a difference! They had the Kemper Klay Gun (which is much, much better) for cheaper than the horrid LC gun. Can't wait to have time to really work with this. --T |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Poly Clay/ wicked Candace | Stephanie | Beads | 49 | September 12th 04 03:07 AM |
Kato clay... | Louise | Polymer Clay | 4 | November 18th 03 11:37 PM |
Sculpey Eraser Clay - one year later | Irwin | Polymer Clay | 3 | October 21st 03 09:06 PM |
Makins and La Doll & other stone ground mineral clays?? | DianeGlassAttic | Polymer Clay | 0 | October 13th 03 06:21 PM |
Modeling clay as a substitute for "clay bars" for auto detailing? | Jon Noring | Polymer Clay | 4 | September 23rd 03 12:36 AM |