If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Alloys
Hi,
I would appreciate any practical advice on preparing a red brass alloy for chasing work. I read about the alloy in Oppi Untracht's book "Jewelry - Concepts and Technology" and would like to apply it in the workshop. Thanks |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Silver in Copper Alloys | [email protected] | Jewelry | 0 | August 6th 06 02:07 AM |
How often does one resize a ring? | [email protected] | Jewelry | 5 | January 12th 06 03:22 AM |
Making safe alloys | [email protected] | Jewelry | 9 | November 28th 05 07:52 AM |
Ring Design | Jack Schmidling | Jewelry | 11 | October 6th 04 05:02 AM |
Common metal alloys | Bungadora | Beads | 13 | April 18th 04 09:35 PM |