If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Dremel Tool
Do many of you carvers use a dremel tool?
-- Thanks, Gregg |
Ads |
#2
|
|||
|
|||
Dremel Tool
"Gregg" spewed out in news:_88kf.43$YM1.25
@fe02.lga: Do many of you carvers use a dremel tool? I do. I also use several other brands of rotary tools. I like using the flexible shaft though. Power carving speed up the process of roughing in. For my first carvings, I almost exclusively used the Dremel tool. I am trying to use it less as I am learning not to grind my cut marks away. Carving my niche- Arnie |
#3
|
|||
|
|||
Dremel Tool
Yes, find it useful to do finish work in spaces where I am not able to get a
tool. Mostly get small pieces of "fuzz" and fine chips out of close spaces. Use a small round bit to fashion eyes where I want to indent the socket. Bill Houdek "Gregg" wrote in message ... Do many of you carvers use a dremel tool? -- Thanks, Gregg |
#4
|
|||
|
|||
Dremel Tool
My wife has always used a Foredom. She doesn't thing a Dremel would
have enough power. You can see a sample of her work at www.distinctive-woodcraft.com |
#5
|
|||
|
|||
Dremel Tool
Instead of a Dremel or Foredom tool I have been using an air powered mini
die grinder. It uses the same 1/8 inch shank bits that these other tools use but it has more speed (about 30,000 rpm) and power than either one of them. You can buy one of these die grinders for about $70 now. -- Charley "bigfoot" wrote in message ups.com... My wife has always used a Foredom. She doesn't thing a Dremel would have enough power. You can see a sample of her work at www.distinctive-woodcraft.com |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OT - Story - the best tool, ever! | Kathy N-V | Beads | 5 | June 28th 05 10:11 PM |
Full Selection of Dremel Tools & Accessories | blokemn | Glass | 10 | January 4th 05 10:02 PM |
Full Selection of Dremel Tools & Accessories | blokemn | Glass | 1 | January 3rd 05 05:07 PM |
Need advice on which Dremel tool model to buy | Scott Smith | General Crafting | 2 | December 31st 04 05:43 PM |
New Thunderbird Looping Tool? | Mj | Beads | 3 | June 26th 04 09:13 PM |