If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
how to on woodcarving
Hi, I have always been interested in wood carving as long as I can
remember. I just don't know where to begin. If anyone could help me as the tools I would need and any other information you think I should know about this topic I would appreciate it. Thanks |
Ads |
#2
|
|||
|
|||
About 4 years ago, was in the same situation. Went to a Woodcraft
store--there are about 60 in the USA, and a kind soul helped me. Got a starter carving set and 2-3 illustrated magazines, some wood (basswood) and went to work. My early work was simple, not pretty but got me started on technique, how to and what not to do. It was also a time to develop what type of "things" I wanted to do. Chip carving was not for me nor too detailed; faces still are my nemeses even though I have several articles on how to do it and have tried some. I get a lot of joy and satisfaction out of the endeavor. One thing helping me is that an Uncle carved 40-50 years age and I have two of his objects which I have sort of copied. Nothing I do is a carbon copy of anything. I just get a basic design and then improvise. This give you a lot of latitude when a cut goes wrong and you take too much wood. One thing I cannot stress too strongly---SAFETY. Get a carving glove and thumb guard--save lots of trips the emergency room. Also, dust filtration is very important. Wood fibers will stay in your lungs for ever and cause all sorts of unnecessary problems. Hope this brief response will give you some help. Bill Houdek "sbeep" wrote in message m... Hi, I have always been interested in wood carving as long as I can remember. I just don't know where to begin. If anyone could help me as the tools I would need and any other information you think I should know about this topic I would appreciate it. Thanks |
#3
|
|||
|
|||
There are a lot of kinds of carving. One of the things you will have to do
is decide what kind you want to do. Some people do minatures others do monumental pieces. There are many different styles and subjects also; carcature, chip carving and decorative, faces and human forms, animals, relief carving, carving in the round, et cetera. Having done that, probably the best way to start is a book and a lesson. As for books there are lots of good books, for example "How to Carve Wood" by Richard Butz. For lessons look around for carving clubs on the internet, community colleges and arts/crafts stores. Stores will often have lessons and if they don't they may have a bulliten board. Get some advice and guidance before buying tools. There is no such thing as a really generic beginers kit; the tools you will need depend on the kind of work you want to do. Also, you shouldn't need a lot of tools initially although as you get deeper into it you will be surprised how qucikly your tool collection grows. Be safety concious; there are a lot of ways to get hurt. "sbeep" wrote in message m... Hi, I have always been interested in wood carving as long as I can remember. I just don't know where to begin. If anyone could help me as the tools I would need and any other information you think I should know about this topic I would appreciate it. Thanks |
Thread Tools | |
Display Modes | |
|
|