|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 6th 03, 05:46 PM
|
|||
|
|||
Embossing on Metal?
Hi
I would like to emboss a silver color on a piece of brass jewelryl. Will any kind of embossing powder stick? Thanks! 
|
| Ads |
|
#2
November 6th 03, 09:42 PM
|
|||
|
|||
|
"CshellX" wrote in message ... Hi I would like to emboss a silver color on a piece of brass jewelryl. Will any kind of embossing powder stick? Thanks! Well, I embossed on metal photo corners and aluminum eyelet letters with no problem. I just rubbed the pieces on my embossing inkpad, sprinkled on the powder and heated it up... quite nice too! Be careful handling afterward though, ouch ouch hot hot. I don't know if you'll get a true silver over brass, but I bet it would be neat anyway. -- Sally Beacham www.dizteq.com/www.lvsonline.com Paint Shop Pro, Filter Frenzy, Xara X sallyATdizteq.com
|
|
#3
November 9th 03, 01:00 PM
|
|||
|
|||
|
I saw on Caroll Duvall they did it on pewter stickers from Magenta. It seemed
just fine. Shawn WIP -- New Baby!
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Creating very light hollow metal ornaments | Marin | General Crafting | 1 | January 17th 08 12:38 AM |
| I want to make a diamond ring | Lush | Jewelry | 17 | June 28th 04 02:48 AM |
| Creating very light hollow metal ornaments | Marin | Jewelry | 8 | January 29th 04 03:39 PM |
| To Quench or not to Quench? | Jenny | Jewelry | 12 | January 19th 04 10:31 PM |
| Embossing powder and embossing tinsel for sale | WKT | Rubberstamps | 3 | August 27th 03 01:52 AM |
Linear Mode
