If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Peter W. Rowe pwrowe@ixDOTnetcomDOTcom wrote in message
. .. [Snipped very useful info please see previous post] Hope this is of use. Peter Rowe Thankyou for such a detailed response. You have absolutely convinced me to rethink the manufacturing process for these prototype parts. Thankyou again Peter, Steve |
Ads |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Ganoksin] [Issue #96] Tips From The Jeweler's Bench | Ganoksin | Beads | 0 | March 20th 04 09:20 AM |
Creating very light hollow metal ornaments | Marin | Jewelry | 8 | January 29th 04 03:39 PM |
J-2R Casting machine Raffle | Ganoksin | Jewelry | 0 | December 16th 03 05:35 AM |
How much 14K gold will a 1/4 ounce of 24K gold yield? | Jeff S. | Jewelry | 10 | October 28th 03 04:43 AM |
need help with vacuum casting | Andrew Werby | Jewelry | 2 | September 5th 03 03:39 PM |