If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
FS: K&F L1HT kiln (1300degC) & ST302 controller - Leicester, UK plus chemicals, moulds etc
The K&F L1HT has internal dimensions 18" x 18" x 18" and external dimensions 33" wide x 36" deep x 60" high. Full set of furniture, shelves & props. 9kW - fires surprisingly easily and accidentally just the once past cone 10! Lightly used since purchased 2nd hand a few years ago. ST302 digital controller with two heating/cooling ramps. Location: south of Leicester, UK. Buyer to collect with trailer & pump truck. Easy access. Offers in excess of £500 (for Kiln and Controller together) to kiln4sale (@) live.co.uk (take out the spaces and brackets!) Also available good range of realistic hobbyist quantities of "Cone10 chemicals" - currently doing an inventory, but if you are interested do ask. Also also available: potters plaster, some clay, some moulds. Again, in the middle of taking inventory, but ask if you are interested and I will expedite. If you take the kiln and controller you can have the clay and plaster for free! The chemicals and moulds will be for sale at around 50% of what they cost me - taking account of the little I have used. They'll be a bargain! email: kiln4sale (@) live.co.uk (without the spaces and brackets) |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Installing three zone controller on your kiln | Davis Salks | Pottery | 11 | January 14th 07 08:16 PM |
ADVERT: Kiln Controller than can be hooked to your computer. | glasstools | Jewelry | 3 | January 2nd 07 01:40 AM |
kiln trouble AIM 84BD with Fuji controller | kellyK | Glass | 16 | June 1st 05 08:53 PM |
Building a kiln controller | liam potts | Glass | 54 | February 16th 05 03:36 AM |
Kiln controller instructions | Steve & Susan Wright | Beads | 0 | July 21st 03 01:24 PM |