If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Cutting mirror with glass cutter...?
"Bill Browne" wrote in newsanxk.208181$102.43438
@bgtnsc05-news.ops.worldnet.att.net: Kris: If you need some help in the electronics aspect of this project, let me know. I have more than a passing knowledge of the subject. Hey, thanks! Sorry for the delayed response - I was preparing for Ike, and then Ike hit...we escaped the worst of it thankfully, but I did a lto of preparations "just in case" Would you mind if I sent you a private email on this? Thanks! -Kris |
Ads |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dover Clip Art Stencils for glass etching and or vinyl cutter | Dennis.Doherty | Glass | 0 | July 11th 06 08:16 PM |
New Glass and Mirror Craft Book Available | Robert | Marketplace | 0 | May 5th 06 11:30 PM |
Lystre on glass in fusion oven (mirror / reflector effect for light) | Søren M | Glass | 16 | November 16th 05 04:05 PM |
mirror and glass etching advice needed | alpha | Glass | 5 | March 12th 05 06:22 PM |
Cutting glass mirror | Chris Mares | Glass | 33 | June 29th 04 05:37 AM |