If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
To drill or pre-pierce?
What are the reasons one would drill a bead after baking instead of piercing
it while soft? How do you drill a squirming, rolling bead, (i.e. what drill, how do you keep it still, etc?) Many thanks from a real newbie! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Available: Glass drill bits (1/2" carbide spade) | [email protected] | Glass | 0 | March 26th 05 02:59 AM |
stone shaping equipment | raane | Jewelry | 12 | January 24th 05 03:36 PM |
Glass grinding bit in a drill press? | MPost | Glass | 1 | October 10th 04 05:05 PM |
Drill for rocks | Mick | Carving | 6 | October 8th 04 12:54 PM |
That little diamond drill bit I use! | Harry | Beads | 5 | January 16th 04 01:25 AM |