|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 15th 05, 02:06 AM
|
|||
|
|||
wedding band to match Tiff plat engagement ring
My fiancee has a 4-prong, light Tiffany style platinum diamond engagement
ring. It's wider at the top near the diamond. What shape wedding band will match it well, in terms of how they wear and rub against each other, etc? The basic style we were looking at was 2 mm plat round comfort fit, but not sure how well they'll sit next to each other given that the wedding band isn't tapered like the engagement ring. TIA, S 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Advice on rub-over settings | Bob | Jewelry | 2 | August 26th 04 04:39 PM |
| Looking for custom cut engagement ring, historical jewelry store, or experienced diamond ring designer in Ontario | Jimmy | Jewelry | 2 | April 29th 04 06:33 AM |
| lots of questions about my ring | tert in seattle | Jewelry | 2 | April 15th 04 03:41 AM |
| "Gunk" Under Prongs in Engagement Ring | sbright | Jewelry | 2 | September 5th 03 03:39 PM |
| wedding ring pattern? | Stale4 | Quilting | 4 | August 17th 03 01:56 AM |
Linear Mode
