![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Okay I have narrowed my search down to these three wheels unless I can find a
used higher end wheel. Any suggestions about how to find one in Phildelphia? I am confused about which one to buy because I have not seen a Clay Boss or a Bailey. Does anyone know which one of the three wheels have better torque for 1- 10 lbs of clay. |
Ads |
#2
|
|||
|
|||
![]() I have a clay boss and like it. It is advertised to center 50 pounds... yeah right... I can't even lift 50 pounds... I do center 10 to 15 pounds on it regularly and have no problems. All those you mention will center 10+ pounds. Tony http://tonyolsen.com/up/ "Lischneid" wrote in message ... Okay I have narrowed my search down to these three wheels unless I can find a used higher end wheel. Any suggestions about how to find one in Phildelphia? I am confused about which one to buy because I have not seen a Clay Boss or a Bailey. Does anyone know which one of the three wheels have better torque for 1- 10 lbs of clay. |
#3
|
|||
|
|||
![]() "tony" wrote in message ... I have a clay boss and like it. It is advertised to center 50 pounds... yeah right... I can't even lift 50 pounds... I do center 10 to 15 pounds on it regularly and have no problems. All those you mention will center 10+ pounds. Tony An electric wheel that cannot cope with 10 pounds has got to be pretty bad ![]() Have a go on the wheels if you can, see which you feel best with. Even if it is not with clay. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Polymer clay cane covered eggs | Wanda | Polymer Clay | 17 | May 27th 04 02:26 AM |
warning: GREAT LAKES CLAY COMPANY (WILL STEAL FROM YOU) | grizzzlyadam | Pottery | 17 | March 19th 04 02:22 AM |
COMM: Shape Boss, Embossing powders, polymer clay | Jan Ruhnow | General Crafting | 0 | November 10th 03 05:19 PM |
Modeling clay as a substitute for "clay bars" for auto detailing? | Jon Noring | Polymer Clay | 4 | September 23rd 03 12:36 AM |
FAQ:Intro to rec.crafts.pottery | Mishy Lowe | Pottery | 0 | July 18th 03 06:05 AM |