|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 10th 07, 02:55 AM
posted to rec.crafts.pottery
|
|||
|
|||
Clay Boss wheel
I am looking for opinions from users of the Clay Boss wheels. It seems they
are the most reasonably priced but are they good for the money? 
|
| Ads |
|
#2
January 10th 07, 02:50 PM
posted to rec.crafts.pottery
|
|||
|
|||
|
Clay Boss wheel
Jim wrote: I am looking for opinions from users of the Clay Boss wheels. It seems they are the most reasonably priced but are they good for the money? Hi Jim, I have a Big Boss wheel and I do like it very much. I like that the splash pan is so easy to remove and easy to clean. the motor is good and strong. I have had absolutly no problems with it. The only thing is, in my opinion, when centering, it doesn't seem to go as fast as the ones we have in the studio where I take classes. But it does go plenty fast enough to do a good job centering. I hope this helps. Sandi
|
|
#3
January 10th 07, 09:16 PM
posted to rec.crafts.pottery
|
|||
|
|||
|
Clay Boss wheel
On Tue, 9 Jan 2007 18:55:26 -0800, "Jim" wrote:
I am looking for opinions from users of the Clay Boss wheels. It seems they are the most reasonably priced but are they good for the money? I've had one for 3 years and have had no problems with it. I used a Brent at university and then tried the Clay Boss at a local studio. I'm happy with both its price and performance. Best, Sue
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Disposing of Glazes | anna | Pottery | 5 | November 21st 06 03:54 AM |
| old spinning wheel | Els van Dam | Yarn | 23 | May 2nd 06 10:24 AM |
| Brent ie, Clay Boss, or Bailey which one shall I buy? | Lischneid | Pottery | 2 | June 13th 04 04:42 AM |
| Modeling clay as a substitute for "clay bars" for auto detailing? | Jon Noring | Polymer Clay | 4 | September 23rd 03 12:36 AM |
| FAQ:Intro to rec.crafts.pottery | Mishy Lowe | Pottery | 0 | July 18th 03 06:05 AM |
Linear Mode
