If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Tack Welders
I just looked at a magazine article in which a person used an ABI Tack
II machine to tack weld many small parts in place before soldering them. Sure made binding wire look like something from the dark ages. And it also seemed to open doors for some design possibilities that I'd never even consider without such a capability. Obviously, it would take a lot of use to pay back the investment, but looking at all the time I spend trying to keep things in place before and during soldering, it looks like it would be a substantial time saver. Would appreciate any comments from folks who use a tack welding machine, and whether they use it more for positioning pieces, or for actually making a finished weld. And whether the higher power models are that much more useful at their bench. Thanks in advance. |
Ads |
Thread Tools | |
Display Modes | |
|
|