If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Polishing clay beads
I make small beads
and it's very hard to polish them. Is there something you can do besides hand-rubbing these beads to make them look finished? Check out the info I have for one quicker way on this page ...using a Scumbuster in a shallow bowl of water with the beads (or possibly a Mouse sander) : http://www.glassattic.com/polymer/sanding_tumbling.htm (in the sub-category "Power Tools") (My info on using a tumbler is various ways is on the same page.) For buffing the beads after sanding to smooth them, check out these pages: http://www.glassattic.com/polymer/buffing.htm http://www.glassattic.com/polymer/to...rksurfaces.htm (for using a Dremel) HTH, Diane B. http://glassattic.com --polymer clay "encyclopedia" E-mail: (don't use AOL address) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
AD-Richmond, VA Nov 1-2, 2003 Old Dominion State Intergalactic Bead Festival | Phineas T Beadd Director National Bead Society | Beads | 0 | October 29th 03 05:57 PM |
AD-Old Dominion State Intergalactic Bead Festival Nov 1-2, 2003 Richmond, VA | Phineas T Beadd Director National Bead Society | Glass | 0 | October 17th 03 02:55 PM |
AD-Oct. 4-5, 2003 Knoxville, TN Appalachian States Intergalactic Bead Festival | Phineas T Beadd Director National Bead Society | Glass | 0 | October 3rd 03 03:56 PM |
AD-Knoxville, TN Oct. 4-5, 2003 Appalachian States Intergalactic Bead Festival | Phineas T Beadd Director National Bead Society | Glass | 0 | September 26th 03 02:12 PM |
AD-Orlando, FL July 12-13, 2003 Florida Summer Classic Intergalactic Bead Festival | Phineas T Beadd Director National Bead Society | Glass | 0 | July 11th 03 06:28 PM |