|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
heat seal or glue?
I'm working on a project and need some advice. My goal is to find the
cheapest and easiest way to "laminate" two sheets of fabric together
with a sheet of netting sandwhiched in the middle.
Still with me?
I'll put a yard of ripstop nylon fabric on the table.
Then I'll lay a same size piece of netting down - similar to this but
made of small wire.. http://www.usnetting.com/HTML/all-purpose.html
Finally I'll put a second yard of ripstop nylon down.
Then I want to glue or heat seal all three layers together.
I can use any type of fabric but I'd like the finished product ( all
three layers fused together) to be somewhat water resistant. Also the
fusing method should be easy to do without an expensive machine.
Think epoxy cement or home clothes iron.
The best I can come up with on my own is to use :
Heat Sealable Oxford
200 Denier, 6.5oz/sq yd. This fabric has a special coating that makes
it possible to be heat-sealed, coated side to coated side, using a
household iron. Perfect for dry bags, spray skirts and all water
sports for which you need a waterproof bag.
Colors: Nickel Gray, Yellow, Royal, Red, Fl. Orange, Black
The netting I'll be using will be thin and will form roughly 1inch by
1inch squares. It should be tough enough to withstand heat or
Anybody have any other ideas? If I used glue I'd be able to use
|Thread||Thread Starter||Forum||Replies||Last Post|
|Press and Seal||She in PA[_2_]||Quilting||11||September 7th 07 07:06 PM|
|Seal of the USA||Fred||Needlework||25||September 8th 06 04:41 PM|
|Press and seal||Estelle Gallagher||Quilting||10||November 12th 05 08:08 PM|
|Press & Seal||julia sidebottom||Quilting||10||August 27th 04 07:17 PM|
|Glue? Glue Sticks?||Renee99||General Crafting||4||November 14th 03 03:53 PM|