If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
vender for a gas burner
Where can I buy an atmospherically-entrained gas burner with about
10,000 Btu/hr max output when using propane? If a burner puts out, say, 10,000 Btu/hr with natural gas, how much will it put out with propane, at the same supply pressure? Thanks in advance. Tom |
Ads |
#2
|
|||
|
|||
On 9 Sep 2003 12:54:58 -0700, (Lathe Dog) wrote:
Where can I buy an atmospherically-entrained gas burner with about 10,000 Btu/hr max output when using propane? If a burner puts out, say, 10,000 Btu/hr with natural gas, how much will it put out with propane, at the same supply pressure? Thanks in advance. Take a look at http://www.wardburner.com/. I took a quick look and didn't see a burner with that low of an output, but dollars to donuts they could fix you up. Their site is also a wealth of info re burners. deg |
#3
|
|||
|
|||
I too have been looking for and trying to make burners. From the Clay
art list I found some folks recommending a burner/tourch called a big bertha that is normally used as a weed burner but made of cast iron and puts out up to 500,000 btu at full power and goes down to a candle flame at low. I have not yet been able to find a retailer for them in the seattle/tacoma area but they must be around here someplace. Lathe Dog wrote: Where can I buy an atmospherically-entrained gas burner with about 10,000 Btu/hr max output when using propane? If a burner puts out, say, 10,000 Btu/hr with natural gas, how much will it put out with propane, at the same supply pressure? Thanks in advance. Tom |
#4
|
|||
|
|||
http://www.wardburner.com/
Lathe Dog wrote: Where can I buy an atmospherically-entrained gas burner with about 10,000 Btu/hr max output when using propane? If a burner puts out, say, 10,000 Btu/hr with natural gas, how much will it put out with propane, at the same supply pressure? Thanks in advance. Tom |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Homemade Surface Mix Burner by Mark Lauckner | William | Glass | 0 | March 8th 04 08:31 PM |
small scale glassblowing with Nortel Minor Burner? | Jean-Francois Theoret | Glass | 4 | March 2nd 04 10:21 PM |
Small Scale Glassblowing with Nortel Minor Burner? | Jean-Francois Theoret | Beads | 24 | March 2nd 04 03:38 AM |