|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 28th 04, 10:01 PM
|
|||
|
|||
machine problem, help please
I just got a Pfaff 2440, and I am sewing along straight stitch piecing, then
the fabric just stops moving along, and the needle sews on ine spot until it pushes the fabric down in a hole and I can't free the fabric or the thread mangle. I have adjusted the top tension and reinstalled the bobbin, turned the SM off and on, cussed at it, begged it, threatened it. Dogs are up and moving as normal, just not grabbing the fabric and moving it. What is causing this and how do I make it stop!? cyndi 
|
| Ads |
|
#2
March 29th 04, 09:19 PM
|
|||
|
|||
|
Hi,
I don't know about the 2440, but on my Pfaff 7570, that happens when I have a piece of thread caught in the tension disks. Did you try flossing them? Hugs, Rhoda
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sewing Machine FAQ | Diana Curtis | Quilting | 2 | January 24th 05 06:57 PM |
| HOW RUBBER STAMPS ARE MADE & how i made $$$ - I AM SELLING MY MACHINE AND METAL SHEETS | Nintendo DS 4 Sale | Rubberstamps | 3 | November 28th 04 12:28 PM |
| Its that time again! FAQ | Diana Curtis | Quilting | 9 | February 1st 04 08:08 PM |
| FAQ RCTQ for newbies and oldtimers alike | Diana Curtis | Quilting | 15 | January 11th 04 06:20 PM |
| Slitting machine, Slitting, Rolling mill, Wire Flattening Mill, Sheet Leveler, Section Leveler, Scalping Machine, Brush Machine, coiler, decoiler, recoiler, 4 Hi, 6 Hi, 4 High, 6 High, Rolling mill, Wire Flattening Mill, Polishing Machine, Rewinding | korak | Quilting | 0 | December 14th 03 05:52 PM |
Linear Mode
