If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Beginner in doubt?
Hi
I`m in Yorkshire in the Uk and use english walnut most of the time. Lime and Pear are very good (soft) hardwoods with close grain. They tend to carve like butter and you get really fine detail with either I use mallet and chisel and not knives so I cannot advise you on how hard you have to hit regards Steve |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Beginner Lampworking Questions | Maeven | Beads | 11 | September 10th 04 04:55 PM |
Another beginner class | JL Amerson | Beads | 9 | April 10th 04 11:44 PM |
Typical beginner question | Cheryl | Beads | 6 | September 6th 03 02:25 AM |