If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Need to blunt engraved edges
After I engrave glass with a diamond bit and router, the edges are too
sharp. The details are too intricate to sand by hand. How can I make this product safe to sell? |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Covering the edges of rooms? | Cathy Weeks | Doll Houses | 1 | March 5th 04 06:43 PM |