If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
cutting surface
I'm looking at a table made of a sheet of plywood for cutting on, 1"
thick and very hard, but I've been offered a formica bar countertop. It's hard and smooth, plus even the smallest flakes and shards will come off cleanly. What are you guys using? ** Posted from http://www.teranews.com ** |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Surface work | lewmew | Needlework | 12 | May 2nd 08 04:33 AM |
Surface Extension Table | Hanne Gottliebsen | Quilting | 4 | March 23rd 05 02:30 PM |
surface finish & titanium | m4816k | Jewelry | 4 | September 30th 04 04:36 PM |
Surface Design Teacher | shhdesigns | Quilting | 0 | April 1st 04 06:13 AM |
crewel and surface.... | ws | Needlework | 6 | March 8th 04 08:07 PM |