|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 4th 03, 11:11 PM
|
|||
|
|||
AD: Sarajane's NEW Polymer Clay Auctions
Hi all!
I just put up over two dozen auctions at Ebay and Just Beads. Egg Ornaments, Girl Beads, Girl Pins, beads strung and unstrung....take a look at all at once at my auctions page. http://www.polyclay.com/Collage/auctions.htm Thanks for looking! Sarajane Sarajane's Polymer Clay Gallery http://www.polyclay.com 
|
| Ads |
|
#2
December 5th 03, 02:23 AM
|
|||
|
|||
|
The link doesn't work. :-(
-- Barbara www.penguintrax.com eBay: pnguintrax Justbeads  enguintrax0 /O\ Need web hosting? Check out http://www.lyonshost.com "Sjpolyclay" wrote in message ... Hi all! I just put up over two dozen auctions at Ebay and Just Beads. Egg Ornaments, Girl Beads, Girl Pins, beads strung and unstrung....take a look at all at once at my auctions page. http://www.polyclay.com/Collage/auctions.htm Thanks for looking! Sarajane Sarajane's Polymer Clay Gallery http://www.polyclay.com
|
|
#3
December 5th 03, 02:41 AM
|
|||
|
|||
|
woops! here's the right URL:
http://www.polyclay.com/Collage/auction.htm Sarajane Sarajane's Polymer Clay Gallery http://www.polyclay.com
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AD: Polymer Clay Auctions ending tonight! | Valerie | Beads | 0 | November 28th 03 08:28 PM |
| AD: Polymer Clay Beads on Justbeads! | Valerie M | Beads | 4 | October 14th 03 05:52 AM |
| AD: Polymer Clay Beads on Justbeads! | Valerie M | Beads | 0 | October 13th 03 06:45 AM |
| ? about finishing Polymer Clay pieces | Karleen/Vibrant Jewels | Beads | 26 | September 24th 03 07:45 PM |
| Need tips on polymer clay | Charlie | Beads | 7 | August 4th 03 10:01 PM |
Linear Mode
