If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
need source for glass tubes
Hi,
I had several sources for glass tubes for making elements but lost my hardrive. - need also good source for mulite rods. - glass tubes for making elements - ANY GOOD THIRD PARTY CONTROLLERS -- "Poor people have access to the courts in the same sense that Christians had access to the lions." - Judge Earl Johnson Jr. |
Ads |
#2
|
|||
|
|||
What kind of controller you looking for? A Cadillac? I can build a Rolls
if you like. -- Jack bobo1148atxmissiondotcom http://photos.yahoo.com/bc/xmissionbobo/ |
#3
|
|||
|
|||
"Boner the Cat" wrote in
: Hi, I had several sources for glass tubes for making elements but lost my hardrive. - need also good source for mulite rods. - glass tubes for making elements - ANY GOOD THIRD PARTY CONTROLLERS I found my source for glass tubing in the yellow pages under scientific glass when I was doing lampwork. If you are in a university town, then you will have a source of scientific glass. When I was a youth, I went to a chem. supply co. bought tubing, erlinmeyer (sp?) flask, rubber stopper, and glass funnel and had a pretty inexpensive water pipe (so long ago we did not even have bongs). Rodger -- Sufficiently advanced incompetence is indistinguishable from malice. -David Sawford- |
#4
|
|||
|
|||
Here is my version:
one is just as dead when shot from a loose canon as one purposely stuck in your ear. Sufficiently advanced incompetence is indistinguishable from malice. -David Sawford- |
#5
|
|||
|
|||
I just want a controller to run my kiln. give a s..t if geo metro or
Lamborghini as long as does what it is supposed to do!!! I do fused glass, 16" x 48" panels (multi layered) I just need to set the ramp speed and hold cooling temps with one soak. nJb" wrote in message ... What kind of controller you looking for? A Cadillac? I can build a Rolls if you like. -- Jack bobo1148atxmissiondotcom http://photos.yahoo.com/bc/xmissionbobo/ |
#6
|
|||
|
|||
Boner the Cat wrote:
I just want a controller to run my kiln. give a s..t if geo metro or Lamborghini as long as does what it is supposed to do!!! I do fused glass, 16" x 48" panels (multi layered) I just need to set the ramp speed and hold cooling temps with one soak. Send me an email. Jack |
#7
|
|||
|
|||
1MgCO3(s) -- 1MgO(s) + 1CO2(g)
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Source for glass cylinder? | Bert | Glass | 8 | July 17th 12 06:00 PM |
Glass Source | Michele Blank | Glass | 12 | July 17th 12 04:39 PM |
ISO 2-strand curved silver tubes | Kimbo | Beads | 8 | March 15th 04 06:31 PM |
Source for matched pairs of furnace glass beads? | April H. | Beads | 1 | October 24th 03 02:09 PM |
Good source for silver beads? | laura | Beads | 4 | August 21st 03 11:08 PM |