|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 6th 04, 12:02 AM
|
|||
|
|||
three legged bowl
Hello Everyone,
I would like to make a slab built bowl (draped over a mold) with texture on the inside and I'd like to put three legs on it. I would be shaping the legs or feet from a slab wrapped around the short end of a wooden spout maker so they will be hollow. My question is do you have to poke a hole in the legs for the air to escape in the firing? Thanks to anyone who answers, Sandi 
|
| Ads |
|
#2
June 6th 04, 08:34 AM
|
|||
|
|||
|
Yes
Steve Bath UK In article , sandi writes Hello Everyone, I would like to make a slab built bowl (draped over a mold) with texture on the inside and I'd like to put three legs on it. I would be shaping the legs or feet from a slab wrapped around the short end of a wooden spout maker so they will be hollow. My question is do you have to poke a hole in the legs for the air to escape in the firing? Thanks to anyone who answers, Sandi -- Steve Mills Bath UK
|
|
#3
June 6th 04, 10:27 AM
|
|||
|
|||
|
and while you have it up side down, put a board and a spirit level on top if
you are particular about the angle on which it stands on the table. Andrea Yes Steve Bath UK In article , sandi writes Hello Everyone, I would like to make a slab built bowl (draped over a mold) with texture on the inside and I'd like to put three legs on it. I would be shaping the legs or feet from a slab wrapped around the short end of a wooden spout maker so they will be hollow. My question is do you have to poke a hole in the legs for the air to escape in the firing? Thanks to anyone who answers, Sandi -- Steve Mills Bath UK
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| creating water i.e. fish bowl / pond | C A . Butler | Polymer Clay | 4 | October 21st 04 05:25 PM |
| Fish Bowl | C A . Butler | Doll Houses | 3 | October 15th 04 02:10 AM |
| New bowl stands | Nancy KP | Marketplace | 0 | October 5th 04 02:19 AM |
| Chip bowl trouble | Uncle John | Pottery | 12 | March 13th 04 02:36 PM |
| old ceramic bowl | Foghat4me | Pottery | 0 | October 20th 03 06:57 PM |
Linear Mode
