If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
From what is plaster made of?
On Tue, 29 Jul 2003 11:45:17 +0300, "A." wrote:
Hello, people! What actually is that material called plaster, from what moulds are made? I have heard somebody doing moulds from gypsum, but is it the same material? ( I' am from the other edge of the world , Estonia, Europe ). What else except water do I have to add to that material if making a mould? And about cones - probably there is no ceramic suppliers selling them in our country. Is it possible to make cones by itself or are they strictly industrial merchandise? Have a nice summer, greetings Plaster is gypsum that has been calcined to remove some of the "chemical" (bound) water. There are different states of hydration, and the one you need for plaster is obtained by roasting the gypsum for many hours at low temperatures, around 300F or so. If the temperature is too high, over 350F or so, the gypsum could go to another hydration state such that it wouldn't be set up when you tried to use it as plaster. Water is the only thing you need to add to plaster to make a mold. For best results with pottery or molding plaster, you would add 70 grams of water for every 100 grams of plaster. Use cold water; hot water may speed up the set too much. Sprinkle the plaster into the water slowly. You can get decent results without weighing if you just sprinkle the plaster until it fills the container to the surface of the water, and then starts to stay on the surface, but weighing is better. Many instructions recommend that you then let it sit (slake) for a couple of minutes before you stir it, but I don't think it's really needed. They also recommend letting the stirred plaster sit until it's just about ready to set up before you pour it, but again I don't think that's needed either. Try to avoid trapping air bubbles when you pour, and after you pour you should hit the container sides to dislodge any trapped bubbles. Then just let it sit. It will get warm as the reaction takes place. You can test the surface by scraping with a nail or something to see how the setting is coming along. Be patient! Hope this helps. Bob Masta dqatechATdaqartaDOTcom D A Q A R T A Data AcQuisition And Real-Time Analysis Shareware from Interstellar Research www.daqarta.com |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Waterproof plaster | Imogen | General Crafting | 3 | December 10th 04 06:56 PM |
My 1st Chance to see Beads made!!! | Empress Beads | Beads | 5 | June 8th 04 02:06 AM |
Genunie Austrian Crystals Made in the USA!!! | Karleen/Vibrant Jewels | Beads | 26 | March 14th 04 07:11 PM |