I need to buy a 'Rolling Mill', any suggestions ?

**[email protected]** · #12 March 12th 09, 05:10 PM posted to rec.crafts.jewelry

On Mar 7, 3:42 am, "FC..." wrote:
Need to get a new Rolling Mill. =A0I don't really want to spend any more
than about $700.00 as my use for it will be VERY basic (texturing
metal, flattening out small ingots). =A0I know nothing about 'rolling
mills' so any suggestions or information would be very welcome.

Thanks,

/FC....

Durston has recently made available a pair of very affordable Mills.
Both have a gear ratio of 4:1 which makes it very easy to do roller
printing. One is a 100mm combination rolling mill for about $710 and
the other is a 100mm Flat rolling mill for about $699.00. They were
able to bring down the price by removing the extension rollers that
did the 1/2 round wire. Which i think few people used anyway.
Rio Grande carries them as well as the other jewlery suppliers that
carry Durston mills.
I hope this is of some help
Mark Nelson
Rio Grande Tech support

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Rolling Mill	Kendall Davies	Jewelry	13	July 17th 12 06:07 PM
rolling mill questions	ted frater	Jewelry	0	September 19th 06 07:38 AM
Calibrating a Rolling Mill	Frosty	Jewelry	5	May 20th 06 03:31 AM
Slitting machine, Slitting, Rolling mill, Wire Flattening Mill, Sheet Leveler, Section Leveler, Scalping Machine, Brush Machine, coiler, decoiler, recoiler, 4 Hi, 6 Hi, 4 High, 6 High, Rolling mill, Wire Flattening Mill, Polishing Machine, Rewinding	korak	Marketplace	0	December 14th 03 05:52 PM
Slitting machine, Slitting, Rolling mill, Wire Flattening Mill, Sheet Leveler, Section Leveler, Scalping Machine, Brush Machine, coiler, decoiler, recoiler, 4 Hi, 6 Hi, 4 High, 6 High, Rolling mill, Wire Flattening Mill, Polishing Machine, Rewinding	korak	Quilting	0	December 14th 03 05:52 PM