|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 29th 05, 05:18 PM
|
|||
|
|||
[ADVERT] CNC ring machine
I am developing a Table Top CNC Gang Tool Lathe.
It will offer various spindle options. It will be available in two, three and four axis models. It will also be available with CANNED ring band programs. respond for more information [[moderator's note:. Please reply by direct email to the poster, not via newsgroup reply posts, if at all possible. Thanks. PWR]] 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FAQs for RCTQ | Diana Curtis | Quilting | 7 | October 4th 04 02:16 AM |
| lots of questions about my ring | tert in seattle | Jewelry | 2 | April 15th 04 03:41 AM |
| FAQs for RCTQ | Diana Curtis | Quilting | 17 | April 2nd 04 07:59 PM |
| Welcome to RCTQ FAQ | Diana Curtis | Quilting | 10 | November 3rd 03 05:43 PM |
| FAQ's on buying a new Sewing Machine | Butterfly | Quilting | 0 | October 17th 03 04:34 PM |
Linear Mode
