If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How to prevent making nicks and marks in wire?
Hello everybody!
I hope this topic has not yet been discussed to death, but I did a search and nothing really came up, so... How can I prevent nicks and marks from my pliers when I work with wire? I have tried several things that were suggested to me: I put both masking tape and duck tape over the plieres. (Not at the same time, of course.) While that was good in the beginning, the surface of both eventually got destroyed and there wasn't really any protection any more. Plus, the sticky stuff made the wire all nasty and slippery, so it was actually harder to get a good grip. (And I had to clean the sticky stuff off afterwards.) Now somebody suggested to superglue thin leather on the gripping surfaces of my pliers. Haven't yet tried it and hope for some input from you. Does anybody know a foolproof solution? Thanks in advance. Jennamyria |
Ads |
#2
|
|||
|
|||
|
#4
|
|||
|
|||
Try using round nose pliers and leaving your wire long so you can use
leverage to bend it rather than another pair of pliers. -Stanley A&M Jewelers Baltimore, MD "Beadbimbo" wrote in message ... Rio Grande sells something called "alligator skin". It's like tape, and you wrap it around your pliers, bu then it comes off, so you can put it on and take it off at will. I think it's great! -- Jerri www.beadbimbo.com To subscribe to the Beadbimbo mailing list, send a blank email to: "Jen" wrote in message ... Hello everybody! I hope this topic has not yet been discussed to death, but I did a search and nothing really came up, so... How can I prevent nicks and marks from my pliers when I work with wire? I have tried several things that were suggested to me: I put both masking tape and duck tape over the plieres. (Not at the same time, of course.) While that was good in the beginning, the surface of both eventually got destroyed and there wasn't really any protection any more. Plus, the sticky stuff made the wire all nasty and slippery, so it was actually harder to get a good grip. (And I had to clean the sticky stuff off afterwards.) Now somebody suggested to superglue thin leather on the gripping surfaces of my pliers. Haven't yet tried it and hope for some input from you. Does anybody know a foolproof solution? Thanks in advance. Jennamyria |
#5
|
|||
|
|||
Hi Jennamyria,
How can I prevent nicks and marks from my pliers when I work with wire? Most times the marks you speak of are caused by the edges of the pliers jaws. Typically, the jaw edges are a sharp 90 deg. They tend to leave marks on wire when the wire is bent. One way to eliminate or alleviate this problem is to round the edges of the jaws just a little. I like to use 400 grit or finer wet dry paper to sand the edges & remove the sharp edge. The only other cause of marks created by wire is too strong a grip. The way around this is to lighten your grip on the pliers. They should be gripped just enough to prevent the wire from moving, not so much that indentations a left in the wire. The right grip comes with practice & experience. Dave |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to prevent making nicks and marks in wire? | Jen | Beads | 9 | December 1st 03 03:50 PM |