If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Question on bezel settings
Dear Jennifer,
If the stone keeps falling, most likely that it doesn't fit well within the bezel. In this case use a small amount of transparent adhesive e.g. super-glue (in general, I try to avoid use of adhesives to maintain the stone clarity, however in cases like you describe it seems necessary). Then, use a manual bezel pusher tool to tighten the bezel around the stone. Good luck, Sarit. http://sarit-jewelry.com |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
A question for lampworkers | Diana Curtis | Beads | 42 | May 7th 04 07:26 PM |
Not really an AD, but a marketing question, need advice | Kandice Seeber | Beads | 26 | April 4th 04 10:39 AM |
Question on bezel settings | Jennynj1975 | Jewelry | 2 | March 10th 04 03:24 PM |
ROLEX bezel replacement | JP | Jewelry | 1 | February 24th 04 03:34 AM |
Another question.... Question about Beading Thread | Ken Knecht | Beads | 3 | July 16th 03 06:24 AM |