If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
polishing scratches from art glass???
If you can feel the scratches with your fingernail, it's likely not going to
be able to be polished out, especially if it is already in a panel. If you still have the loose piece, you might could take it through the steps of beveling, i.e.; roughing, smoothing, pre-polish and final polish. You'll have to grind the surrounding area down "level" with the bottom of the scratch you made, then smooth and polish it. I think you'll find it more trouble than it's worth. JavaHut who posts here regularly would be more likely to know the exact techniques. Maybe he'll post you an answer? "Boner the Cat" wrote in message om... HI, I need to polish some small scratches from artglass, caused when the dremel walked while drilling hole. these do not appear to be deep and are only 2-3 inches long. don't have a lot just the occasional but don't want to throw out the pieces of glass. any suggestion? any type of polishing wheel for the Dremel. thks http://www.Starpath-designs.com bg -- "Not everything that can be counted counts, and not everything that counts can be counted. " Albert Einstein (1879-1955) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help from the US glass people, please? | Su/Cutworks | Beads | 21 | October 7th 04 10:14 PM |
For those who want to know.. Making Beach Glass With Your Tumbler! | Harry | Beads | 7 | December 22nd 03 08:19 PM |
Your polishing grit and walnut shell can be used over and over. | Harry | Beads | 37 | December 22nd 03 08:03 PM |
Large Sized Stained Glass | Greg DeBacker | Glass | 8 | August 20th 03 03:30 PM |
Old glass receipts | Matthew Spong | Glass | 0 | July 4th 03 01:06 PM |