If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Improving stainless steel knitting needles.
I have found that by abrading a band behind the points of my commercial SS
knitting needles I can vastly improve their usability and "friendliness." With the improved needles, my problems with dropped stitches disappears and my knitting speed significantly improves. In addition, tight stitches are easier. I use 1500 wet or dye emery paper, stretched over a curved surface to VERY gently abrade the center one-third of the needle-point taper. The points are left highly polished and the rest of the needle is left highly polished. For example, on a pair of US #1 needles with a 0.4 inch long taper; the abraded band around the needle is about 0.12 inches wide and located about 0.2 inches behind the point. This abrasive is a special order at my hardware store. I believe that white diamondtine applied with a hard felt wheel would achieve the same effect, but have not tried it. The modification when tried with the widely available 1000 grit created enough roughness to be noticeable on fibers such as alpaca, but was OK for common wools, and actually better for courser wools and sock yarns. Synthetics and silks have not evaluated. In most light, the band is barely visible as a darker area on the needle. The abraded area is just rough enough to be detected by a change in friction as you slide a finger across the area. This modification has not been tried on plated brass needles. Try it. I think you will like it. Aaron |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ebay: some newly listed interesting items: knitting needle lots, looms, vintage sewing needles etc | marilyn safier | Marketplace | 0 | December 6th 04 05:33 PM |
TOYOTA KNITTING MACHINE NEEDLES | Jue | Machine Knit | 9 | October 10th 04 12:31 PM |
tumbling stainless steel | Robert Stenson | Jewelry | 1 | September 24th 04 02:22 AM |
Common metal alloys | Bungadora | Beads | 13 | April 18th 04 09:35 PM |
Where to get stainless steel signet ring "blanks"? (driving me nuts!) | Jeff S. | Jewelry | 2 | October 27th 03 06:17 AM |