If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Mokume Anyone?
Hi Guys,
Anyone doing Mokume on the list? Regards Charles |
Ads |
#2
|
|||
|
|||
Mokume Anyone?
On May 8, 6:23=A0am, Chilla wrote:
Hi Guys, Anyone doing Mokume on the list? Regards Charles I've done a tiny bit of silver/copper. Clean, stack, clamp between two thick steel plates, bake, product! :-) Have you had a go ? Richard |
#3
|
|||
|
|||
Mokume Anyone?
jarkman wrote:
On May 8, 6:23 am, Chilla wrote: Hi Guys, Anyone doing Mokume on the list? Regards Charles I've done a tiny bit of silver/copper. Clean, stack, clamp between two thick steel plates, bake, product! :-) Have you had a go ? Richard I've doen pattern welding with ferrous metals, I've read Ferguson's book,and the steps are very similar. Lower temperatures, and no flux seem to be the main differeces. I have some gold and silver ready to go. I need to get some clean copper, and then I'll melt a few into traditional ingots. Regards Charles |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Need info about soldering / setting stones in mokume gane. | Chris | Jewelry | 5 | May 19th 07 08:39 PM |
polyclay mokume gane (was crafts contest) | Barbara Forbes-Lyons | Polymer Clay | 4 | August 16th 05 02:00 PM |
soldering mokume ring | redsmith-israel | Jewelry | 2 | March 20th 05 01:19 AM |
Mokume Gane materials question | Greyangel | Jewelry | 16 | March 14th 05 03:44 AM |