If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
refractory materials question.
Hello. I am only loosely connected with glass in that I am a potter
working with glazes. However I am wondering if anyone could help me out with some information. Last year I built a kiln (4m², wood fired). The bricks (more big blocks actually) that I built it with came from a glass works. I being a fairly young potter, was following the advice of a more experienced potter in the area, who convinced me that these blocks were fine for building a pottery kiln as they were certainly refractory, having come from the glass industry. The guy I bought them from had them in his yard for a number of years since the glass works closed down and he reclaimed them. As you can understand he had no knowledge of the quality of the blocks. To cut a long story short, I built my kiln, packed it and preheated it for over a week before bringing up the temperature (slowly) to begin the firing. To my horror I saw the bricks at the front of the kiln starting to crack and splinter... I stopped the firing. The potter who advised me on buying the bricks is convinced that the bricks still had some humidity in them and this was the reason. I do not think so. they were under shelter for a good six months, and the preheating was in my opinion long enough. Having spoken with people who have some more technical knowledge, I now believe that the reason is more to do with the composition of the bricks themselves. From what I understand, in the glass industry the refractory materials are often almost pure silica. If this were the case with my big blocks, then would I be right in thinking that they would react in this way to a relatively fast rise in temperature (my intention was to fire the kiln to 1300°C over three days)? I cannot say at what temperature the cracking started, but I would say no higher than 500-600°C at the very most. If anyone has any information to offer on the subject then I would be most grateful. Alistair, St Amand en Puisaye, France. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Finding materials - for a special ornament - Question | [email protected] | General Crafting | 1 | December 9th 05 05:48 PM |
Victoria Sampler Materials Question | Nadia Abbasi | Needlework | 3 | August 22nd 05 08:33 PM |
Mokume Gane materials question | Greyangel | Jewelry | 16 | March 14th 05 03:44 AM |
Raw materials | C A . Butler | Polymer Clay | 1 | October 17th 04 02:40 AM |
Repair refractory material in a Paragon kiln? | kay lancaster | Pottery | 1 | July 28th 03 10:18 PM |