|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 9th 05, 11:50 AM
|
|||
|
|||
Need help with Toyota KR501 Ribber
I'm a newbie Machine Knitter, having bought a KS901 machine and KR501 ribber on ebay about 9 months ago. The KS901 works great, but every time I try to use the ribber, I end up breaking or bending needles and going nuts. I've checked the assembly, and I believe I'm following the instructions correctly, but I can't figure out why the needles are jamming.
Does anyone have any wisdom (or suggestions) to impart regarding this? (I've already installed new Sponge Bars for both the Knitter and the Ribber.) Thanks. Last edited by RJ Squirrel : September 9th 05 at 03:15 PM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anyone here know about Toyota Elena Auto 7? | GailM | Machine Knit | 19 | December 10th 12 04:02 AM |
| Ribber Jamming | Joy Hardie | Machine Knit | 3 | December 19th 04 11:33 AM |
| Newbie with a ribber, keeps jamming! Please help | steel breeze | Machine Knit | 1 | November 1st 04 01:50 PM |
| Toyota KS901 | Betsy | Machine Knit | 3 | April 20th 04 01:52 PM |
| ribber combs | reltuc | Machine Knit | 0 | September 25th 03 02:38 PM |
Threaded Mode