If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Help with elements?
I am putting the elements in a skutt 1027. I have the elements in an
now am putting the connectors to the box. I clamped the connectors to the box wires and before I took them off I numbered the wires 1, 2, 3, and 4. 1 going to the top element, 2 going to the same element but down one. I got three and four on according to the sequence, but then put 1 where I should have put 2. It goes to the same element. Will it make a difference with the switch if I leave it as is or am I going to have to cut the connector off and put it on as numbered? I really did not want to have to cut the connector off unless I absolutely have to. I know, I know pay attention right................ Randy |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Kiln Elements | Kevin Baldwin | Pottery | 3 | July 3rd 04 08:34 PM |
kiln questions - front loading | Steve Worcester | Glass | 14 | June 8th 04 06:52 AM |
Fun with Texture | Lindsay MacArthur | Pottery | 42 | February 12th 04 05:26 PM |
Kiln not heating up as much any more | Uncle John | Pottery | 7 | September 9th 03 11:56 PM |
elements | Gretl IoW | Pottery | 3 | July 20th 03 06:08 PM |