If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Heat and Bond lite
After being a WonderUnder user for many years, I switched to Heat and Bond
lite for fusible appliqué projects. At first I ignored the instructions (after all, I KNEW how to fuse!) and I wasn't happy with the results. So I have tried fusing with their directions and am still not very happy, Here's what happens.... I get the image of the bumps on the front side of the appliqué piece, especially on lighter fabrics. So I thought maybe I was still fusing too long, or too hot....but when reduced both, I didn't get a good fuse. Have any of you been consistently successful with this fusible? It might be a little more flexible than WonderUnder, but I'm not seeing much difference. Any ideas? -- Kathyl yup, that's an L http://community.webshots.com/user/kathylquiltz |
Thread Tools | |
Display Modes | |
|
|