If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
PANEL and DOME shade makers...need an opinion
I have developed a workable, easy to use and set up jig (or fixture) that
will enable one to level and solder panel lamps and small domes. the shade can be leveled on a rod and held in place thus freeing BOTH HANDS. only 23 years of experience and about 1,050 or so shades of all sizes..... If I can find a market for this, I could easily go into production on an "on demand basis" if you are a shade maker....feel free to reply here; TIA HOWARD -- In the words of the IMMORTAL USED CAR DEALER: THERE IS AN ASS FOR EVERY SEAT! |
Ads |
#2
|
|||
|
|||
Could you post photo of same (somewhere)?
"Howard" wrote in message ... I have developed a workable, easy to use and set up jig (or fixture) that will enable one to level and solder panel lamps and small domes. the shade can be leveled on a rod and held in place thus freeing BOTH HANDS. only 23 years of experience and about 1,050 or so shades of all sizes..... If I can find a market for this, I could easily go into production on an "on demand basis" if you are a shade maker....feel free to reply here; TIA HOWARD -- In the words of the IMMORTAL USED CAR DEALER: THERE IS AN ASS FOR EVERY SEAT! |
#3
|
|||
|
|||
Randy Wardell, in one or some of his books, has a simple to build jug
that works great. I built one so can attest to the fact that it works just fine. total cost to build is under $5.00. Andy "Moonraker" wrote in message ... Could you post photo of same (somewhere)? "Howard" wrote in message ... I have developed a workable, easy to use and set up jig (or fixture) that will enable one to level and solder panel lamps and small domes. the shade can be leveled on a rod and held in place thus freeing BOTH HANDS. only 23 years of experience and about 1,050 or so shades of all sizes..... If I can find a market for this, I could easily go into production on an "on demand basis" if you are a shade maker....feel free to reply here; TIA HOWARD -- In the words of the IMMORTAL USED CAR DEALER: THERE IS AN ASS FOR EVERY SEAT! |
Thread Tools | |
Display Modes | |
|
|