If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
kiln venting question
I have a toploading electric kiln firing up to 1300º. is it necessary to
continue venting the kiln area once the cooling down has started? thanx |
Ads |
#2
|
|||
|
|||
No, unless you want the kiln to cool down a bit quicker than normal. Most
harmful emissions are gone by the time the kiln has reached red heat anyway. Dave "potty" wrote in message ... I have a toploading electric kiln firing up to 1300º. is it necessary to continue venting the kiln area once the cooling down has started? thanx |
#3
|
|||
|
|||
In article ,
"David Coggins" wrote: thanx Dave |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Important - Please beware of a company called Bohle | Eric Russell | Glass | 2 | August 23rd 04 07:46 PM |
FAQ Raku part 2 of 2 | SBRANFPOTS | Pottery | 0 | September 16th 03 11:11 PM |
kiln wash question | psci_kw | Pottery | 1 | July 26th 03 11:51 PM |
Raku FAQs | Tom Buck | Pottery | 0 | July 20th 03 04:49 AM |
Kiln question | Kalera Stratton | Beads | 13 | July 11th 03 06:35 AM |