If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Firing Tmes
Hi Pete,
There are about as many firing cycles as there are glaze recipes. There is no definitive answer, but have a look at my website www.users.bigpond.com/dcoggins for a few pointers. Bisque temps for pottery are specified by the clay suppliers, usually at least 1000C but not too high, as the glaze won't stick. High bisque firings/ low gloss firings are used in slipcast ceramics - the high bisque to vitrify the clay, and the low glaze temp to retain the bright colours. Glazes for this method have lots of gums to make them stick to the vitrified clay. Main thing in bisque firing cycles is to control temp rise until moisture and inorganics are gone, and silica is converted - usually red heat. Hoe this helps a bit Regards Dave "potty" wrote in message news Hi everybody we've just acquired our first electric kiln with a good controller. I'm a bit confused about firing cycles though as some articles recommend one schedule, the controller manual recommends another etc etc etc. At college all biscuit firings went to 1040șC for both stoneware and earthenware work obviously for the sake of standardising and this seemed to work realy well but several sources (including the manual) advised bisque firing to 1140/1180 for subsequent glost firings at around 1080 - what's that all about. I usually reference Hamers' Dictionary but no sample firing cycles are included although good info on the specific stages are explained (as they are on digitalfire's site. Can anyone recommend a good publication including or specialising in this subject or even give me some pointers. Thanks in advance Pete |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
fusing novice question (firing schedule) | Bonnie | Glass | 2 | January 18th 05 08:36 AM |
A66 Kiln... Firing times? | MS A | Pottery | 3 | August 17th 03 11:15 PM |
Raku FAQs | Tom Buck | Pottery | 0 | July 20th 03 04:49 AM |
FAQ:Intro to rec.crafts.pottery | Mishy Lowe | Pottery | 0 | July 18th 03 06:05 AM |
Bisque firing temp? | GaSeku | Pottery | 7 | July 10th 03 07:52 PM |