If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
technology transfer from the garden
Steel knitting needles sometimes need to be reground. The best tool that I
have found for that is the little ceramic sharpening stone that Felco sells to sharpen its pruning shears. It has a groove that runs down one side of its generaly triangular cross-section. The bottom of the groove is rounded and makes getting a nice rounded tip easy. I use a bit of WD-40 as cutting oil Do not try to regrind aluminium needles. Aaron |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Iron on Transfer Paper | hpman247 | Marketplace | 0 | December 23rd 04 08:02 AM |
July FQ Swap - In the House/Around the Garden | Yvonne Stuchell | Quilting | 0 | July 11th 04 08:19 PM |
AD: Millenium Garden Workshops | Stephen | Polymer Clay | 0 | August 16th 03 03:33 AM |
June Taylor Copy'n Press Transfer Paper | me | Quilting | 0 | July 21st 03 12:40 AM |