If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Ir filtration system - any recommendations?
Hi, ALl, I was wondering whether anyone is familiar with air-
filtration/fume hood type systems suitble for a very small in-home glassworking bench. Best would be somehting that coudl be lifted onto the working surface during soldering/grinding (tho' I intend to do most of my grinding outside, as I have a covered porch), then lifted off and moved when I'm wither scoring glass, or using the table for some other purpose. TIA! - Kris |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ODS drilling system | Jack[_2_] | Glass | 0 | March 16th 07 08:54 AM |
Needlework System 4? | Katherine Hutter | Needlework | 1 | October 11th 04 02:28 AM |
System 96 Rods | starlia | Beads | 1 | July 9th 04 08:46 PM |
24K plating system on TV? | jk | Glass | 0 | June 5th 04 02:19 AM |
Anyone use Flynn system | Audrey Eischens | Quilting | 1 | November 25th 03 01:55 AM |