If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Handles
"L.Mac" wrote in message om... I seem to have hit a wall in the handle making department. I was doing fine with both pulled and rolled handles but suddenly I can't seem to make one to same my life. Actually, my problem is in attaching the handle--they don't want to go on or stay on. The biggest problem is with cracking when I attach the top part and then curve it to attach the bottom part. Does anybody have any suggestions? Thanks for your time. L.Mac So, what you're saying is they crack when you bend them? That it's pulling off when you try to get it to the shape you want? Cecilia |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Another Mystery "heirloom" | Jack Schmidling | Jewelry | 20 | March 26th 11 08:11 PM |
AD - Four new vessels going up - Tink | Tinkster | Beads | 3 | November 21st 04 07:10 AM |
turning old silverware into kitchen pull handles | terry | Jewelry | 6 | June 5th 04 04:59 PM |
Beginners Knife?? | Jim Warren | Carving | 5 | March 17th 04 05:36 PM |
tips on handles | GaSeku | Pottery | 8 | July 17th 03 07:51 AM |