![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Excuse my ignorance, but I was wondering how (if it's possible) to cut
tempered glass.? i have a number of old equipment cabinet doors which would be nice to re-use however they are very large approx 2000 mm x 500 mm and about 5mm thick. It seems a pity to throw them away. |
Ads |
#2
|
|||
|
|||
![]()
R&R-
Tempered glass cannot be cut. It can, however, be etched / shaded by someone (i.e., me) who does sandblasting. I take it (seing as how you quoted the sizes in mm) that you're nowhere near the west coast of Florida? ~s "Raff & Rebeca" wrote in message ... Excuse my ignorance, but I was wondering how (if it's possible) to cut tempered glass.? i have a number of old equipment cabinet doors which would be nice to re-use however they are very large approx 2000 mm x 500 mm and about 5mm thick. It seems a pity to throw them away. |
#3
|
|||
|
|||
![]() "Steve Roberts" wrote in message ink.net... R&R- Tempered glass cannot be cut. It can, however, be etched / shaded by someone (i.e., me) who does sandblasting. I take it (seing as how you quoted the sizes in mm) that you're nowhere near the west coast of Florida? ~s Your right Steve, He's in Australia, no where near the west coast of FL. Your best bet is to find a Tempering plant at a glass factory nearest you, (ask the local glass guys where they order their tempered from after telling them why you want the info) The tempering plant has miss runs all the time, somebody reads dimensions wrong, or puts the logo in the wrong corner, scratched pieces, etc. you may be able to get it at a serious discount. |
#4
|
|||
|
|||
![]()
Given the messing around and the price to recover this glass as usable
smaller pieces it is cheaper to drop it on a piece of concrete and buy new glass. However you could have it annealed, recut and retempered, but again the energy balance does not work out, recycle it and buy some new glass if you need it.. "Raff & Rebeca" wrote in message ... Excuse my ignorance, but I was wondering how (if it's possible) to cut tempered glass.? i have a number of old equipment cabinet doors which would be nice to re-use however they are very large approx 2000 mm x 500 mm and about 5mm thick. It seems a pity to throw them away. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
For those who want to know.. Making Beach Glass With Your Tumbler! | Harry | Beads | 7 | December 22nd 03 08:19 PM |
Glass cutting lubricant | Charles A. Peavey | Glass | 22 | November 7th 03 07:55 PM |
Microscope Slide - Glass Cutting Jig | MaryJLind | Beads | 6 | September 10th 03 02:03 PM |
cutting glass into thin sections | jad_23 | Glass | 8 | August 9th 03 03:51 PM |
Old glass receipts | Matthew Spong | Glass | 0 | July 4th 03 01:06 PM |