|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
FS: K&F L1HT kiln (1300degC) & ST302 controller - Leicester, UK plus chemicals, moulds etc
The K&F L1HT has internal dimensions 18" x 18" x 18" and external
dimensions 33" wide x 36" deep x 60" high. Full set of furniture,
shelves & props.
9kW - fires surprisingly easily and accidentally just the once past
cone 10! Lightly used since purchased 2nd hand a few years ago.
ST302 digital controller with two heating/cooling ramps.
Location: south of Leicester, UK. Buyer to collect with trailer & pump
truck. Easy access.
Offers in excess of £500 (for Kiln and Controller together) to
kiln4sale (@) live.co.uk (take out the spaces and brackets!)
Also available good range of realistic hobbyist quantities of "Cone10
chemicals" - currently doing an inventory, but if you are interested
Also also available: potters plaster, some clay, some moulds. Again,
in the middle of taking inventory, but ask if you are interested and I
If you take the kiln and controller you can have the clay and plaster
The chemicals and moulds will be for sale at around 50% of what they
cost me - taking account of the little I have used. They'll be a
email: kiln4sale (@) live.co.uk (without the spaces and brackets)
|Thread||Thread Starter||Forum||Replies||Last Post|
|Installing three zone controller on your kiln||Davis Salks||Pottery||11||January 14th 07 08:16 PM|
|ADVERT: Kiln Controller than can be hooked to your computer.||glasstools||Jewelry||3||January 2nd 07 01:40 AM|
|kiln trouble AIM 84BD with Fuji controller||kellyK||Glass||16||June 1st 05 08:53 PM|
|Building a kiln controller||liam potts||Glass||54||February 16th 05 03:36 AM|
|Kiln controller instructions||Steve & Susan Wright||Beads||0||July 21st 03 01:24 PM|