If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
more specific about janome 10001 & gigahoop & design problems
maybe someone has had the same problem...
when i try to do a design with the gigahoop that has ends that must match exactly (like a big circle or square), i size the design in embird, then use customizer to put it back together. then i print out the templates and make sure they line up EXACTLY with the clothsetter. BUT NO.....when i sew up the 1st side, it looks great. i turn the hoop and try the second side and they don't come anywhere NEAR lining up... i called the dealer to ask if they knew how to do it and was told, no, the resident ace there had the same problem. that most designs only need to "come close" to look good, not match up exactly--they had taken the problem to janome but no fix yet... there MUST be a way to do this...anyone else have this problem? what did you do?? |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HELP PLEASE with janome 10001 and bobbin problem | [email protected] | Sewing | 4 | December 1st 03 11:25 AM |
SewingTrader - Janome (Cards, stand, videos etc) Auctions ending Sunday 24th | SewingTrader | Marketplace | 0 | August 24th 03 02:58 PM |