If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2 questions
You might want to try a "bead roller", they are plastic doohickeys you
use to roll a bead shape, they come with holes that you use to guide a pin through, since it is still in the shaped bead trough it doesn't distort. They make a few different shape beads. I am using canes but only abstract patterns like stripes so far, I use them in combination with other techniques. Ingrid CindyB wrote: Do most of you who make beads use canes? I've just spent a very enjoyable morning drooling over the clay creations on justbeads and it looks like a lot of them were made from canes. I've never made a cane before. My other question is about holes. How do you get a hole that goes right through the middle, starts where you want it and ends up exactly where it belongs and doesn't change the bead shape? Sometimes I get lucky and other times it's a big oops! TIA CindyB |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
So...my questions | lizard-gumbo | Needlework | 61 | June 13th 05 10:58 AM |
The ten questions I want you to answer | Jalynne | Beads | 19 | June 22nd 04 08:58 PM |
Questions About Hardanger | Suzanne | Needlework | 7 | April 23rd 04 11:49 PM |
Some additional questions | Steve Lamb | Beads | 15 | April 3rd 04 03:25 PM |
eq5 questions | Karlee in Kansas | Quilting | 20 | December 17th 03 11:53 PM |