If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
HELP - Questions - Stains
I would try some detergent gently. If that doesn't work try one of the
stain removers made by Carbona (Jo-Ann's carries them) or Z'out (which I get at the grocery store). Cleaning the iron depends on what needs cleaning. Iron-off works well to clean the soleplate of the iron, but if the problem is dirty steam, then try running a batch of half water half white vinegar through the iron. That will clean the insides, a bunch of cruddy steam will come out and then clean the sole plate with the Iron-off. Good luck, Pati, in Phx MelissaInNJ wrote: I just finished a YBR Baby Quilt. During the making of it got some small dirt stains on the quilt from my iron (which I now apparently have to clean). I hand washed the quilt and was sure they would come out. They have lessened some but are still there. I'd like to treat the ares before rewashing so that they will be assured of coming out (I don't want to wash this 900x before the giving of it). What would you use to spot treat these dirt marks. I can't describe the stain anymore than it is "dirty". Second question, what would you use to clean the iron. Thanks! Melissa in NJ |
Ads |
#2
|
|||
|
|||
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
The ten questions I want you to answer | Jalynne | Beads | 19 | June 22nd 04 08:58 PM |
lots of questions about my ring | tert in seattle | Jewelry | 2 | April 15th 04 03:41 AM |
Some additional questions | Steve Lamb | Beads | 15 | April 3rd 04 03:25 PM |
newbie questions | Umberto Ramirez | Polymer Clay | 3 | December 29th 03 05:02 PM |
AD and dumb questions from a newbie | Nathalie Lebreux | Beads | 7 | September 9th 03 09:45 PM |